Differences

This shows you the differences between two versions of the page.

--- klipper_faq:flash_guide:stm32g0b1:btt_ebb36_ebb42_can [2024/01/07 11:19] – [kurzer Test] dominik
+++ klipper_faq:flash_guide:stm32g0b1:btt_ebb36_ebb42_can [2025/02/23 10:56] (current) – [YouTube Video #68] dominik
@@ Line 10: / Line 10: @@
 **U2C** \\ {{:klipper_faq:flash_guide:stm32g0b1:pasted:20231111-182853.png}}
-===== YouTube Video #68 =====
+===== YouTube Video #81 =====
-{{youtube>xxx?half}}
+{{youtube>AIT1QGeYRao?half}}
 \\
@@ Line 191: / Line 191: @@
     * ''wget 'https://raw.githubusercontent.com/bigtreetech/EBB/master/EBB%20CAN%20V1.1%20(STM32G0B1)/sample-bigtreetech-ebb-canbus-v1.1.cfg' -O BTT_EBB.cfg''
   * **Version 1.2**
-    * ''wget 'https://raw.githubusercontent.com/bigtreetech/EBB/master/EBB%20CAN%20V1.1%20(STM32G0B1)/sample-bigtreetech-ebb-canbus-v1.2.cfg' -O BTT_EBB.cfg''
+    * ''wget 'https://github.com/bigtreetech/EBB/raw/master/EBB%20CAN%20V1.1%20and%20V1.2%20(STM32G0B1)/sample-bigtreetech-ebb-canbus-v1.2.cfg' -O BTT_EBB.cfg''
   * ''nano ~/printer_data/config/BTT_EBB.cfg'' \\ <code>[mcu EBBCan]
 #serial: /dev/serial/by-id/usb-Klipper_Klipper_firmware_12345-if00
@@ Line 204: / Line 204: @@
   * Vor dem Firmware Update natürlich erstmal Klipper in Mainsail updaten (Machine Seite)!
   * Klipper Dienst stoppen \\ ''sudo systemctl stop klipper.service''
-  * Klipper Kompilieren \\ siehe [[klipper_faq:flash_guide:stm32g0b1:ebb_sb2209_can#klipper_per_katapult|Klipper per Katapult]]
+  * Klipper Kompilieren \\ siehe [[klipper_faq:flash_guide:stm32g0b1:btt_ebb36_ebb42_can#klipper_per_katapult|Klipper per Katapult]]
   * Klipper aufspielen \\ ''~/klippy-env/bin/python3 ~/katapult/scripts/flash_can.py -i can0 -f ~/klipper/out/klipper.bin -u <uuid>''
     * Die UUID von eurem Board eintragen!